Seat occupancy sensor airbag bypass MAZDA
Comprando 5 uds. o mas - 20% descuento
Passenger seat occupancy sensor airbag bypass MAZDA
Plug&Play seat occupancy sensor bypass solution for very common MAZDA problem – active AIRBAG warning light.
MAZDA 626 1991 – 2002
MAZDA 6 (first generation) 2002 – 2007
MAZDA DEMIO 1998 – 2003
MAZDA TRIBUTE 2000 – 2008
MAZDA MPV 1999 – 2006
MAZDA MX-5 ( MX5 ) 1998 – 2005
Attention: It is not recommended to bring children in front in the child seat as the airbag may harm your child in case of an accident – it cannot be disconnected. Kindly note that this solution should only be temporary, we always recommend original replacement parts.
It is very simple Plug&Play item, just plug it under passenger seat . Few minutes to install. In very RARE cases airbag system errors needs to be cleared using special diagnostic equipment. Typically warning light goes off after installation. Detailed installation instructions bellow.
- Remove the car key.
- Below front passenger seat look for sensor connector, disconnect it and leave it as it is.
- Than you can connect our emulator.
- That is all – the light should go off immediately – if it is still ON then clear faults
with diagnostics (in garage).